had a good sortout in the garage and im now ready to start fitting the engine and box!!!!!
guess what i will be doing christmas day!!!!!
finally got the chassis 'rolling' today!!!
had a good sortout in the garage and im now ready to start fitting the engine and box!!!!!
guess what i will be doing christmas day!!!!!
Nice workmanship fella, correct me if i'm wrong, but your upper harness mount may need a little more bracing.
ATB Dan.
yes...they where allready fitted to the chassis like this, but im not happy with them so will be strengthening them...
cheers
boggle
quote:
Originally posted by boggle
guess what i will be doing christmas day!!!!!
, For info just looked up the forces involved, a 30mph crash subjects the upper harnesses to a force of 2.4 tons.
Cars looking great, nice to see more being built to such a high standard.
ATB Dan.
cheers guys
im probably going to remove the threaded fittings completly and mount the harness to the cage, which is going to be cross braced and diagonaled to the
chassis....
blimey doesn't look like you have had any snow!? You can have some of ours if you want, I think we will be snowed in tomorrow morning
not a thing down here....just rain..
quote:
Originally posted by iscmatt
blimey doesn't look like you have had any snow!? You can have some of ours if you want, I think we will be snowed in tomorrow morning
You'll regret fitting the fuel filler there! Guess how I know!
Looking good
I can't see any brake pipes or master cylinders installed yet. I wouldn't fit the engine and gearbox untill you have run the brake and fuel
lines, unless it is only a trial fitting of course.
cheers peeps
the engine will come out again....
it hasnt been run since its rebuild 5years ago so i want to plop it in and see if it fires up, had an endoscope down the bores and they are rust free
and it turns over by hand ok....once im happy with it i will remove and do my brakes...will also give me a chance to see where i can fit the loom and
plum all my lines....
good progreess there.
too cold to do anythig here
I really like your dash, how did you make it? What will you be using for the edges for IVA?
quote:
Originally posted by marcjagman
I really like your dash, how did you make it? What will you be using for the edges for IVA?