Hi all,

As above,

can anyone tell me the exact measurements i need for my prop shaft. Also, anyone recomend a good place to go to , to get it done?

Thanks,

Well the distance depends on where you bolt the engine and box in the front bit of the car!.

I believe you measure from the Lip of the oil seal in the gearbox to the flat of the Flange on the diff. As a worst case draw where you measured from on a bit of paper with diagram.
I assume this is to get you propshaft made / shortened.

I am sure someone will correct me if I am wrong.

As an afterthought, Ring Luego tomorrow and ask them.



[Edited on 5/12/2004 by wilkingj]

Don't know abput the measurement. Ive got a different setup but I have fitted everything to get the measurement. That way I Know it's right.

I'm about to order mine from Bailey Morris http://www.baileymorris.co.uk/ they make them brand new no exchange at £125 +VAT. May be a bit on the expensive side but it is a brand new item and their quality looks good. Also they were recommended by Luego.

But if anyone else has a better supplier/suggestion I might change my mind.

Have used Bailey Morris in the past, can recommend thier services . Not cheap but first class products.