I've just got round to fitting the front hubs, and there isn't enough of the bottom ball joint protruding through the hub to reach the top of the nyloc. I have used Maxi bottom ball joint as advised.

Has anyone else come across this problem or am I missing something

Cheers

Darren

It's alright, I've used me loaf and realised they need to be drilled out to suit the maxi ball joints

Just havin a blonde moment.

Cheers
Darren

LOL. I have them all the time. You are correct mate they do have to be machined!

Luego will do it for a very small consideration, and they have the jig to get the angles right etc... mine were a 15 min job to do them both... I didnt even get time to finish the coffee Should have taken then with you when you picked up the chassis..