Its not m10 anybody know if its unf/unc/bnwotsit etc?

7/16 unf - I think

thought it was 5/16
could be wrong usually am
it could be 3/8

[Edited on 2/5/06 by k33ts]

bad news - think your indicators are a SVA fail. Nat looked at putting his there and couldn't get the 40 degrees of viewing angle.

Just install side repeaters, you'll likely need these to meet the indicator flash speed requirements too.

DG

mine is 7/16 UNF, and you need to drill and fit Roll pins through the Nuts and bar for the SVA.
I got some nylock nuts, only to find out you need roll pins.. 's how I kow its 7/16" UNF.

Where do the pins need to go?

Through the nuts themselves, or through the bit where the bias bar joins the clevis thing on the master cyl?

Cheers

David