Board logo

Luego brake balance bar set up.
Paul (Notts) - 30/12/07 at 01:19 PM

Luego brake balance bar set up.

Two years ago I had two locking nuts that I carefully drilled out ready to fit a roll pin in to lock the balance bar.—I have put these in a very safe place and now cant find them!!!!!

Any body know what thread size the balance bar is on the luego assembly?

It looks close to m12 but a finer thread..

Paul

Howlor - 30/12/07 at 01:37 PM

7/16th? IIRC

Paul (Notts) - 30/12/07 at 01:38 PM

Cheers..

thats what I as just thinking myself..

Paul

tks - 30/12/07 at 02:59 PM

Our own balance bar using a 7/16 UNF threaded shaft.

look at raldes think thats the one my luego uses...

Tks

tks - 30/12/07 at 03:02 PM

How can you undo the bias bar / brake pedal if you dont want to undo the master cilinders??

You would think that turning it to one side should just work but for me it doesn't (the other pushthinky presses against the centre ball..

Tks

richard thomas - 30/12/07 at 04:59 PM

quote:
Originally posted by tks
How can you undo the bias bar / brake pedal if you dont want to undo the master cilinders??

You would think that turning it to one side should just work but for me it doesn't (the other pushthinky presses against the centre ball..

Tks


If I understand that correctly, you have the two pushthinkies too tight to the centre tube...

I am still not sure which master cylinder pushrod the centre ball should be wound closest to in order to favour that cylinder for more bias - can anyone enlighten me?

hector - 30/12/07 at 06:33 PM

Hi they are 7/16 unf

Optimum Balance Products - 2/1/08 at 11:52 PM

Hi, they are 7/16 unf.

Have a look at this link may help.

http://www.obp.uk.net/pedal%20box/Pedal%20Box.htm

If you email me at sales@obp.uk.net i have a help sheet on the bias bar set up.

All the best,
Grant.