Hi all just finnished the cut out for the exhaust in the bonnet.thought it might be help full to thoughs embarking on this job and not sure how to go about it .

Vin .
Rescued attachment kit car 002.jpg

Pic 2
Rescued attachment kit car 003.jpg

pic 3


Sorry for the size but tried to reduce
Rescued attachment kit car 004.jpg

Lookd good for cutting i started using one of those tools but found it much easier to use a jigsaw and tidy up with a sanding drum on the dremil

they do tend to wander off in the direction they rotate but found it best to just use the tip . the only reason i used this cutter was because of all the curves which the jig saw would of struggled with
I finnished off with drum wheel and rotary files to finnish

I don't have one of these tools but i used a dremmel to the same effect