westclad
|
 posted on 21/1/10 at 09:31 PM |
|
|
zetec engine mounts
Hi, Where is the best place to get zetec engine mounts from??
|
|
|
|
|
coozer
|
| posted on 21/1/10 at 09:32 PM |
|
|
For RWD?? Make them.
1972 V8 Jago
1980 Z750
|
|
|
big-vee-twin
|
| posted on 21/1/10 at 10:28 PM |
|
|
Have a look at kitpartsdirect.com - GBS (Robin Hood) they do some
Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016
http://www.triangleltd.com
|
|
|
norfolkluego
|
| posted on 21/1/10 at 10:37 PM |
|
|
As said make them (or get them made), simple enough, just measure accurately and a good welder with some steel stock can make them up in minutes.
If you're a bit unsure, make up a couple of dummies out of wood (couple or square bits of ply (5ml or so thick) and some broom handle/thick
dowel (or similar) cut to the correct angle. Get your engine in the correct position, drop in your rubber mounts, tape 1 ply square over the mounting
holes in the block, the other over the rubber mount (drill a hole) then carefully cut the dowel to length, glue the whole lot together, jobs a good
un. Take that to your fabricator and get it made.
Now I wish I'd done that to start with!
[Edited on 21/1/10 by norfolkluego]
|
|
|
Danozeman
|
| posted on 22/1/10 at 07:20 AM |
|
|
Mine came from GTS for not alot. Its up to you whether or not you decide to get from them.
I think mac#1 and fisher do them.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
doddy
|
| posted on 22/1/10 at 08:32 AM |
|
|
here a help full site if you make them
http://www.toyne.org.uk/docs-mount.html
|
|
|
lotusmadandy
|
| posted on 22/1/10 at 12:04 PM |
|
|
As said above,make them. i made mine,it took all of about 40 minutes to do and cost nothing.
Andy
|
|
|
