Ferg
|
| posted on 10/7/05 at 05:30 PM |
|
|
Velocity XT Rear Hub (Drum Brakes)
Has anyone assembled these rear uprights and hubs???? Luego suggest that the backplate is spaced off the upright (because of the shape of the
backplate) with washers, but I have shown a spacer on my (playgroup style)drawing. Due to the way the shaft outer joint sits the hole in the upright
is a good 4-5 mm too small since the shaft MUST go though to a certain extent. Has anyone made this hole bigger...or are our shafts a bigger
diameter???
All advice gratefully received, I can tell you........
|
|
|
|
|
tks
|
| posted on 10/7/05 at 09:17 PM |
|
|
uhhh
guess
what you try to is right...
measure up the hole and your shaft..
surely one of us can come up with the righ measure ment?
The above comments are always meant to be from the above persons perspective.
|
|
|
Mark18
|
| posted on 11/7/05 at 02:43 PM |
|
|
The shafts on the 3.14 diff I had were strangely slightly bigger - I'd never heard of any mention of this before, but maybe your shafts are the
same? Regardless, I can't see any reason not to make the hole bigger if the shafts wont fit.
Mark
"I don't know what I may seem to the world. But as to myself I seem to have been only like a boy playing on the seashore and diverting myself
now and then finding a smoother pebble or a prettier shell than the ordinary, whilst the great ocean of truth lay all undiscovered before me." -
Isaac Newton
|
|
|
