darrens
|
| posted on 14/8/05 at 06:59 PM |
|
|
Front Hubs viento
I've just got round to fitting the front hubs, and there isn't enough of the bottom ball joint protruding through the hub to reach the top
of the nyloc. I have used Maxi bottom ball joint as advised.
Has anyone else come across this problem or am I missing something
Cheers
Darren
|
|
|
|
|
darrens
|
| posted on 14/8/05 at 07:04 PM |
|
|
It's alright, I've used me loaf and realised they need to be drilled out to suit the maxi ball joints
Just havin a blonde moment.
Cheers
Darren
|
|
|
Danozeman
|
| posted on 15/8/05 at 08:27 AM |
|
|
LOL. I have them all the time. You are correct mate they do have to be machined!
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
wilkingj
|
| posted on 26/8/05 at 07:20 PM |
|
|
Luego will do it for a very small consideration, and they have the jig to get the angles right etc... mine were a 15 min job to do them both... I
didnt even get time to finish the coffee Should have taken then with you when you picked up the chassis..
1. The point of a journey is not to arrive.
2. Never take life seriously. Nobody gets out alive anyway.
Best Regards
Geoff
http://www.v8viento.co.uk
|
|
|
