irvined
|
 posted on 2/5/06 at 08:55 PM |
|
|
Bias bar thread
Its not m10  anybody know if its unf/unc/bnwotsit etc?
http://irvined.blogspot.com
|
|
|
|
|
JohnN
|
| posted on 2/5/06 at 08:58 PM |
|
|
7/16 unf - I think
|
|
|
k33ts
|
| posted on 2/5/06 at 09:33 PM |
|
|
thought it was 5/16
could be wrong usually am
it could be 3/8
[Edited on 2/5/06 by k33ts]
tukcustoms.com
|
|
|
MikeR
|
| posted on 2/5/06 at 11:34 PM |
|
|
bad news - think your indicators are a SVA fail. Nat looked at putting his there and couldn't get the 40 degrees of viewing angle.
|
|
|
dozracing
|
| posted on 3/5/06 at 09:06 AM |
|
|
Just install side repeaters, you'll likely need these to meet the indicator flash speed requirements too.
DG
|
PLEASE NOTE: This user is a trader who has not signed up for the LocostBuilders registration scheme. If this post is advertising a commercial product or service, please report it by clicking here.
|
wilkingj
|
| posted on 3/5/06 at 09:12 AM |
|
|
mine is 7/16 UNF, and you need to drill and fit Roll pins through the Nuts and bar for the SVA.
I got some nylock nuts, only to find out you need roll pins.. 's how I kow its 7/16" UNF.
1. The point of a journey is not to arrive.
2. Never take life seriously. Nobody gets out alive anyway.
Best Regards
Geoff
http://www.v8viento.co.uk
|
|
|
irvined
|
| posted on 3/5/06 at 09:56 AM |
|
|
Where do the pins need to go?
Through the nuts themselves, or through the bit where the bias bar joins the clevis thing on the master cyl?
Cheers
David
http://irvined.blogspot.com
|
|
|
