vinnievector
|
posted on 21/3/09 at 10:11 AM |
|
|
hi
Hi all just finnished the cut out for the exhaust in the bonnet.thought it might be help full to thoughs embarking on this job and not sure how to go
about it .
Vin .
![](/galpreviews/a910928-kit car 002.jpg) ![Rescued attachment kit car 002.jpg](/gallery/a910928-kit car 002.jpg) Rescued attachment kit car 002.jpg
|
|
|
vinnievector
|
posted on 21/3/09 at 10:14 AM |
|
|
Pic 2
![](/galpreviews/a910930-kit car 003.jpg) ![Rescued attachment kit car 003.jpg](/gallery/a910930-kit car 003.jpg) Rescued attachment kit car 003.jpg
|
|
vinnievector
|
posted on 21/3/09 at 10:19 AM |
|
|
pic 3
Sorry for the size but tried to reduce
![](/galpreviews/a910932-kit car 004.jpg) ![Rescued attachment kit car 004.jpg](/gallery/a910932-kit car 004.jpg) Rescued attachment kit car 004.jpg
|
|
Pdlewis
|
posted on 21/3/09 at 10:20 AM |
|
|
Lookd good for cutting i started using one of those tools but found it much easier to use a jigsaw and tidy up with a sanding drum on the dremil
Build Photo Album
Updated 05/02/2009
|
|
vinnievector
|
posted on 21/3/09 at 10:32 AM |
|
|
they do tend to wander off in the direction they rotate but found it best to just use the tip . the only reason i used this cutter was because of all
the curves which the jig saw would of struggled with
I finnished off with drum wheel and rotary files to finnish
|
|
iscmatt
|
posted on 21/3/09 at 11:45 AM |
|
|
I don't have one of these tools but i used a dremmel to the same effect
|
|