Z20let Corsa
|
posted on 19/5/09 at 07:39 PM |
|
|
double angles?? any tips???
well. on the la, lb, lc, ld tubes on the double angles i just dround them in with a bench grinder till they fitted. i am now at the stage to fit the
rear tubes for the front wishbones (cant remember the references.) Are there any easy ways of cutting them right or am i best just grinding bit by bit
till its right?? thanks. John.
|
|
|
James
|
posted on 19/5/09 at 07:53 PM |
|
|
For producing the 'L' assembly I would recommend cutting each face of the tube. That was how I got it right on the 3rd attempt!
As for the 'FU' tubes, they aren't double angles!
Don't forget they should sit about 6mm in from the top outer chassis rail.
To be honest though, you're best fitting them when you're fitting the wishbone brackets! Use your bracket jig to set the FU tubes at the
same time.
If you don't do it that way I practically garantee you'll be grinding them out again anyway!!!
HTH,
James
------------------------------------------------------------------------------------------------------------
"The fight is won or lost far away from witnesses, behind the lines, in the gym and out there on the road, long before I dance under those lights."
- Muhammad Ali
|
|
mark chandler
|
posted on 19/5/09 at 10:40 PM |
|
|
Bit of card wrapped around a dummy short bit of tube, cut with sizzors until the shape is correct then transfer across to the correct one.
Just as easy to cut close and whittle away in reality.
Regards Mark
|
|
PaulBuz
|
posted on 24/5/09 at 07:24 PM |
|
|
quote: Originally posted by James
If you don't do it that way I practically garantee you'll be grinding them out again anyway!!!
HTH,
James
Spoken like a true locost builder!
Oh the memories
ATB
Paul
|
|