Sierra
|
posted on 22/8/14 at 03:57 PM |
|
|
Griffin inlet plenum swap
But of a long shot but thought I'd try anyway.
I've currently got a griffin plenum and would like to swap for a spencer ashley type plenum. Only reason is I need one that's angled
upwards for clearance on the supercharger.
Is this a TRADE ADVERTISEMENT?? Click HERE to report it!
|
|
|
big_wasa
|
posted on 22/8/14 at 08:43 PM |
|
|
If I had one I would bite your hand of as they are NASTY.
pepper performance / Spencer Ashley = same thing.
|
|
Sierra
|
posted on 22/8/14 at 08:49 PM |
|
|
I've heard that they have changed and just awaiting pictures from them so shall see.
|
|
mark chandler
|
posted on 22/8/14 at 09:27 PM |
|
|
Cannot you get someone to modify what you have, it sounds like you just need a bit of metal added or a wedge cut out to change the angle so saves
messing around with injectors, loom, fuel rail etc?
|
|
big_wasa
|
posted on 22/8/14 at 09:51 PM |
|
|
Ok I would love to see them.
|
|
Sierra
|
posted on 22/8/14 at 09:56 PM |
|
|
quote: Originally posted by mark chandler
Cannot you get someone to modify what you have, it sounds like you just need a bit of metal added or a wedge cut out to change the angle so saves
messing around with injectors, loom, fuel rail etc?
I did look into it but the only way would be to cut it at the flange and angle the 4 ports about 25 degrees, the problem would then be that the
injectors would be at a strange angle and may mess things up.
|
|
mark chandler
|
posted on 23/8/14 at 08:02 AM |
|
|
My injectors are running upside down without any problem, with 3-4 bar of pressure behind them they do not care.
Get a 90 degree mandrel bend, chop it into 4 even parts and weld in
|
|