Clarke Engine Stand
Never used, heavy, would prefer pick up but will send by carrier at cost.
£35 Link
SOLD
Engine trolley/stand.
Never used, got it for a V8 but only suitable for a 4 cylinder.
£20+P&P Item No.:158857E Engine cradle
Mig Welder: Wolfe 135
Got this for a specific job, it still has wire left on the tiny reel that it came with.
The wire speed controller has been changed for a PWM module and the feed rollers
have had a stiffening plate fitted. Scuff mark on top.
£100, heavy (35 kilo’s I think) so would prefer pick up, but will send by carrier at cost if needed.
Large Blast Cabinet
Made this out of zinc coated sheet steel big enough to get a RV8 block in.
Front opening door, fitted interior lights, gun and hoses.
Doesn't have fitted gloves, but these are available from Frost's. I used elbow length rubber gloves.
Also comes with a few kilo's of glass beads and a roll of view window protector.
Exterior Dimensions: 82cmWx95cmHx62cmDepth.
Door Dimensions:77cmWx38cmH
Doesn't have a stand, I fixed a couple of bearers to the wall and the side of a bench.
£60+carriage or pick up
[Edited on 13-3-12 by 40inches]
[Edited on 15-3-12 by 40inches]