ernie
|
| posted on 30/3/05 at 01:21 PM |
|
|
bonnet sealing/ vents
where can I source 1mm mesh to cover my vents? if anybody is still looking for thick foam rubber for carb sealing I have ordered some and should have
a bit spare when finshed, will be at Brands on 23rd or can post if required.
|
|
|
|
|
Hellfire
|
| posted on 30/3/05 at 01:36 PM |
|
|
B&Q sell it in aluminium. About £10/0.5m. Bit dear I thought but when there is little alternative what chance have you got?
|
|
|
Rob Palin
|
| posted on 30/3/05 at 02:39 PM |
|
|
I've used the "David's aluminium bodywork repair mesh" that i picked up from the shop down the road for £1.50 per sheet (200mm
square, i think).
The holes in the mesh are diamond-shaped and slightly larger than 1mm if you measure lengthways. It's pretty damn fine though and the scrutes
didn't look twice at it at Mallory.
It's funny that Robin Knight reckoned that the bonnet sealing thing was an MSA requirement which they had to (reluctantly) pass on, yet if you
look in the safety section of the Blue Book it is nowhere to be seen. Hmmm.
|
|
|
Jon Ison
|
| posted on 30/3/05 at 04:21 PM |
|
|
I got pulled on it at Mallory, as i read the regs i thought i was ok as i'm rear engined, they let me race as the 750regs do state front engined
cars with no reference to rear engine (i had him check it) He went on to give me a hard time with the rest of the car though so Iv,e since covered it
as above with body repair mesh as i aint gonna fall out with scrutineers.
|
|
|
britishtrident
|
| posted on 30/3/05 at 05:55 PM |
|
|
Ikea waste paper baskets and desk trays -- anodized various colours including black and silver --- dirt cheap
|
|
|
