ernie
|
| posted on 18/1/09 at 06:13 PM |
|
|
carburetter fuel union
Just checking the car for new season and found my fuel union to carb is the press fit type. I have a screw in union from an old facet pump which might
fit if I try and cut a thread in the carb inlet. Is there another way before I might ruin a good carb?
|
|
|
|
|
procomp
|
| posted on 19/1/09 at 08:02 AM |
|
|
Hi Ernie
There is no other way realy you have to tap a thread into the carb for the screw in union. Just check what thread it is you have as they are not all
the same.
Cheers Matt
|
|
|
ernie
|
| posted on 19/1/09 at 07:48 PM |
|
|
thanks matt
|
|
|
