stuart_g
|
posted on 12/1/10 at 04:47 PM |
|
|
WTD: 22mm to 16mm 90degree bend
I need a 22mm - 16mm 90 degree bend for part of the cooling system.
I have one of the silicon type hoses but it is only 100mm long in each direction and I need the 22mm side to be 175mm long. I could extend it but it
would mean buying a 1 meter length of blue silicon hose just to use 75mm off it. I don't fancy trawling round breakers yards trying to find
something off a production car so does anyone know where I might be able to get a hose like this.
Another alternative is to find a plastic/metal 22-16 elbow and then use rubber hose off this but I can't find one of these either.
Can anyone suggest anyhting.
|
|
|
jacko
|
posted on 12/1/10 at 06:07 PM |
|
|
How about copper pipe?this is mine
[Edited on 12/1/10 by jacko]
|
|
speed8
|
posted on 12/1/10 at 06:21 PM |
|
|
I might have a bit of 22mm in the garage. I'll check later and if I have it I can stick it in the post for you.
|
|
aitch
|
posted on 12/1/10 at 06:27 PM |
|
|
took the words right out of my mouth
yeah copper pipe
aitch
|
|
splitrivet
|
posted on 12/1/10 at 06:46 PM |
|
|
A Yorkshire 22mm elbow with a 22 to 15mm reducer soldered into it all off the shelf plumbing fittings available from your local B&Q whorehouse
would do the job.
Cheers,
Bob
[Edited on 12/1/10 by splitrivet]
I used to be a Werewolf but I'm alright nowwoooooooooooooo
|
|
BenB
|
posted on 12/1/10 at 07:00 PM |
|
|
Yup. That's wot I was thinking too Nice bit of copper pipe and job's a good'un.
|
|
britishtrident
|
posted on 12/1/10 at 07:40 PM |
|
|
22mm bore is an odd size for a cooling system normally 19mm (3/4" or 25mm (1".
19mm to 15mm (5/8" is easy eough just use a plastic 19mm -15mm -19mm plastic T and blpck off the the unwanted 19mm side by screwing in a bolt.
[I] “ What use our work, Bennet, if we cannot care for those we love? .”
― From BBC TV/Amazon's Ripper Street.
[/I]
|
|
Peteff
|
posted on 12/1/10 at 07:48 PM |
|
|
Solder a straight fitting on the end of your 15mm pipe to build up the width, I did that to increase a 22mm and if you use solder ring fittings the
ridge helps locate the rubber pipe over it when you clip behind it.
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
speed8
|
posted on 12/1/10 at 10:07 PM |
|
|
Checked, I have some 19mm and 25mm.
As mentioned, just get some copper pipe to make the bend. I used it to make a U bend over my steering rack.
|
|