femster87
|
posted on 16/1/11 at 05:15 PM |
|
|
Griffin Inlet plenum
Just dropped in my engine this morning to find out the plenum would not fit. So I know this would not fit a GBS zero. It is the rear facing one.
Pictures have been uploaded into my archives in the for sale folder. £120 + postage
I have two zetec head gasket. both MLS. Bought them off this forum. With new cylinder head boths - £30 ono for the lot + postage.
Is this a TRADE ADVERTISEMENT?? Click HERE to report it!
|
|
|
big_wasa
|
posted on 16/1/11 at 05:24 PM |
|
|
Femi I am after a head gasket if its a 2.0
|
|
femster87
|
posted on 16/1/11 at 06:09 PM |
|
|
its a 2.0 litre one. BGA gasket
|
|
hootsno1
|
posted on 16/1/11 at 06:38 PM |
|
|
can you not cut the inlet tubes and turn the plenum round and re weld it
|
|
femster87
|
posted on 16/1/11 at 07:25 PM |
|
|
I can't weld that well. so I dont't even want to try. Also the tube go into the plenum
[Edited on 16/1/11 by femster87]
|
|
AndyW
|
posted on 18/1/11 at 06:39 PM |
|
|
GBS have a pre production inlet plenum, looks a real nice piece too, they are just waiting to dyno it to see results but apparently (according to
Richard) they have had really good results from it on the red demo, still not sure when it will be "for sale" though. Might be worth
talking to Richard and asking, he didnt know last week but he was trying to pack up for the show when I was hassling him!!!
|
|
M$RK_VXRD
|
posted on 23/1/11 at 03:58 PM |
|
|
u2u pelnum chamber
|
|
femster87
|
posted on 23/1/11 at 05:09 PM |
|
|
All SOLD.
Thanks
|
|