Board logo

help setting up dd2 speedo
shaun fulcrum - 4/8/09 at 02:01 PM

I have driven it but nothing happened. May be really stupid but am I supposed to tell it to work the first time?

I have a 362 slipper and a 954 blade with the magnets on the driveshaft (dot side up)

The dash has speedo cal: 6328 primary ratio: 1521 gear1: 2692 gear2: 1933 gear3:1600 gear4: 1400 gear5: 1286 gear6: 1190

I have tried googling my engine ratios but couldn't find anything, these figures were all already on the dash.

Also do I need a heat shield on my exhaust for SVA re-test? its only the silencer on show.

Any help much appreciated
Thanks Shaun


Andy B - 4/8/09 at 02:56 PM

Hi Shaun
just spotted your post -
the dot side of the magnet should go down so this is probably the issue
regards
Andy


shaun fulcrum - 4/8/09 at 03:09 PM

What a numpty!! Ok will turn them over cheers Andy