Hi all,

Below is a photo of my top harness mounts. Everything is contactable by a 100mm sphere (except the underside edge of the welded-in brace plates) - so I'm guessing the whole lot needs to have a radius => 2.5mm? Including the bolt heads?

And the harness holes in the seat too, correct?



Thanks!
Josh

Rubber U-trim and bolt covers wil do the trick.

This is what Westfield sell/use.

I had some knocked up in some black vinyl at a local trimmers for a tenner.

quote:

---

Originally posted by Toprivetguns
Rubber U-trim and bolt covers wil do the trick.

---