IVA manual states “Min separation distance from stop lamp 100mm”.
Is this from the centre of the lights or outer edge to outer edge? if it’s outer edge to outer edge then ill need to fit separate fog for IVA as mine
is probably too close.
Its in the manual.
Rear Fog Lamp to Rear Brake Lamp separation distance must be
measured between the “illuminating surface” of each lamp. “Illuminating
Surface” should be taken to be the area of the “reflector” to the rear of
the bulbs.
Where lamps are mounted in a common housing and are “E” marked,
the separation criteria should be assumed to be met.
[Edited on 14-8-18 by loggyboy]
thanks for the info loggyboy, ill need to add a fog light on my rear panel for the IVA. As per photo below the four lights have a side-light halo,
outer lights have indicator and brake, inner lights have both fog and reverse. Was just planning on using fog on O/S and reverse on N/S. All four
lights pointing directly to the rear.
If the car is going for IVA, take the number plate off, or you may get done for no tax,mot or insurance among other things.
quote:
Originally posted by Schrodinger
If the car is going for IVA, take the number plate off, or you may get done for no tax,mot or insurance among other things.
Where will you be taking it for the IVA?
do those lights have reflectors built in? or do you need to add some
quote:
Originally posted by Schrodinger
Where will you be taking it for the IVA?
quote:
Originally posted by gremlin1234
do those lights have reflectors built in? or do you need to add some