Board logo

SVA queries
nick205 - 19/7/06 at 01:11 PM

Tried searching on this, but....

What does the SVA man look for around the pedal area?

Cheers
Nick

BKLOCO - 19/7/06 at 01:19 PM

1 loud pedal. (go)
1 soft pedal (stop)
1 other on the left (not sure what that one's for.)

Seriously though.
Nothing as far as I know.
As long as ther are secure and fit for purpose you should be ok.

Oh and brake and clutch must be non slip (not bare metal)

[Edited on 19-7-06 by BKLOCO]

nick205 - 19/7/06 at 02:36 PM

What about sharp edges?

Hellfire - 19/7/06 at 03:31 PM

AFAIK - as long as it's not blatantly a bad build with SHARP EDGES you'll be ok. Just file round edges to remove burrs...

Alan_Thomas - 19/7/06 at 04:20 PM

quote:
Originally posted by nick205
Tried searching on this, but....

What does the SVA man look for around the pedal area?

Cheers
Nick


I believe you cannot get away with an adjustable balance bar if you are using twin master cylinders. Balance bar must be locked in position.

- Alan

nick205 - 19/7/06 at 05:43 PM

cheers guys!

no balance bar in my set-up, just bog standard Sierra m/c

Chippy - 19/7/06 at 08:16 PM

Pretty sure that you have to have non slip pedals, either propper rubbers, or some heavy grit sanding cloth. I used a bit of a worn belt, from a belt sander on my throttle, no probs. Regards Ray.