daniel mason
|
| posted on 21/2/09 at 06:40 PM |
|
|
harnesses and seats
are there any regulations for harnesses for sva,or are they fine as long as they are e'marked?
Also are the low backed tub style plastic seats(supplied by mnr) ok for sva or will i need a high backed bucket seat eg intarim to match my drivers
seat.
The car i have was for track use so only has 1 harness and 1 high back seat!
|
|
|
|
|
blakep82
|
| posted on 21/2/09 at 06:42 PM |
|
|
nooo not this question again lol
everyone will tell you they HAVE to be e-marled, but they don't. there's several other markings they can have instead. look through the
manual and it'll tell you everything in there
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
Steve Hignett
|
| posted on 21/2/09 at 06:47 PM |
|
|
Your passenger side seat will be fine. It might need a bit of edging trim round it just to make it "internal radius compliant", but
that's it.
|
|
|
Stuart_B
|
| posted on 21/2/09 at 06:54 PM |
|
|
they have to been made out of a seatbelt mertail and be at least 40mm or have a e- mark.
stuart
|
|
|
blakep82
|
| posted on 21/2/09 at 06:55 PM |
|
|
^ or any of the other acceptable standards...
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
daniel mason
|
| posted on 21/2/09 at 06:57 PM |
|
|
thanks everyone, i just need 1 so where would be the best place to buy one?
the bay?
|
|
|
blakep82
|
| posted on 21/2/09 at 06:58 PM |
|
|
http://www.locostbuilders.co.uk/viewthread.php?tid=103837
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
TimC
|
| posted on 21/2/09 at 07:12 PM |
|
|
The TRS harness was from Colin Denyer Motorsport based at the Top Gear test track.
Was very good value too. They do standard 2 inch road harnesses.
On that bombshell we have to end the post...
|
|
|
.jpg)
