nstrug
|
| posted on 5/4/09 at 06:24 PM |
|
|
Fitting a decibel insert?
I've now got a Jetex decibel insert but wondering how it should fit - specifically, should the narrower end point towards the tailpipe or
towards the engine?
Also, where would the best place to fit it in the Dax repackable exhaust be - towards the tailpipe, in the middle of the exhaust, or towards the
cat?
Any suggestions welcome.
Nick
|
|
|
|
|
The Baron
|
| posted on 5/4/09 at 06:27 PM |
|
|
I had to use one of those sort of things to get through my SVA, i used the one from CBS.
I have the narrow end pointing towards the engine.
Cheers,
B
|
|
|
snapper
|
| posted on 5/4/09 at 06:33 PM |
|
|
It matters not which way you use it, be aware however it really does make your emmisions go up
I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)
|
|
|
NeilP
|
| posted on 5/4/09 at 06:59 PM |
|
|
I put mine in front of the cans as I have just enough straight section of pipe to allow this - I did cut them down a little as well as I found they
were restricted too much gas flow at full beans...
If you pay peanuts...
Mentale, yar? Yar, mentale!
Drive it like you stole it!
|
|
|
nstrug
|
| posted on 5/4/09 at 08:38 PM |
|
|
Thanks everyone.
I don't really care about the emissions - this is just to get through my SVA retest and as I passed emissions the first time, they will
hopefully not get retested.
Nick
|
|
|
