diyer
|
| posted on 12/1/06 at 05:47 PM |
|
|
fuel pipes
Hi, is it ok (sva'able) to use plastic fuel pipe runs, if i have documentation to show that the pipe is fuel resistant??
thanks
Simon
|
|
|
|
|
Danozeman
|
| posted on 12/1/06 at 05:56 PM |
|
|
Yep.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
diyer
|
| posted on 12/1/06 at 06:04 PM |
|
|
cheers Dan
|
|
|
emsfactory
|
| posted on 12/1/06 at 06:39 PM |
|
|
I used plastic fuel pipe and mr SVA didn't say a thing.
|
|
|
Mark Allanson
|
| posted on 12/1/06 at 07:02 PM |
|
|
It has to have the correct numbers printed on it though
If you can keep you head, whilst all others around you are losing theirs, you are not fully aware of the situation
|
|
|
NS Dev
|
| posted on 12/1/06 at 11:54 PM |
|
|
Does stainless braided teflon line (aeroquip) need any marking on it............I assume not!
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|
|
DarrenW
|
| posted on 13/1/06 at 11:27 AM |
|
|
I used braided fuel lines from tank to carb, no markings and nothing said by tester. Only thing he picked up on was that fuel filler pipe (ie into
tank) didnt have markings. I had to get letter from Mac#1 to warrant it and show approvals - he was then happy.
|
|
|
