Dickyboy
|
| posted on 19/10/10 at 10:18 AM |
|
|
Another IVA projections query
I have fitted a fibreglass rear valance, never thought about it at the time but the bottom edge where it fits to the square section tube is a fairly
sharp square edge, from what I read in the IVA manual this will be a problem. Can anyone confirm/refute? I could fit a rubber L section strip, will be
difficult to change the section of the valance itself when is on a squre tube, any other ideas?
|
|
|
|
|
interestedparty
|
| posted on 19/10/10 at 12:09 PM |
|
|
If it's conactable, then it will need to meet the radius requirements, whic I think are 3.2mm for external stuff. Rubber strip will only help if
it is considered 'permanent'.
Answer might be to get a radius gauge and rub the edge down til it complies.
As some day it may happen that a victim must be found,
I've got a little list-- I've got a little list
Of society offenders who might well be underground,
And who never would be missed-- who never would be missed!
|
|
|
stevegough
|
| posted on 19/10/10 at 02:30 PM |
|
|
I wasn't aware of this until I came across this one last night, page 128 of the manual - "exterior projections".
10.
Where contactable with the 100mm sphere a glass/fibre reinforced plastic panel edge must have a radius of curvature of at least 1.5mm.
Might not be quite the problem you thought it was, Dickyboy!
Luego Locost C20XE.
Build start: October 6th 2008.
IVA passed Jan 28th 2011.
First drive Feb 10th 2011.
First show: Stoneleigh 1st/2nd May 2011.
'Used up' first engine may 3rd 2011!
Back on the road with 2nd engine may 24th
First PASA mad drive 26/7/11
Sold to Mike in Methyr Tydvil 19/03/14
|
|
|
