zetec7
|
posted on 16/6/06 at 05:08 PM |
|
|
Zetec PCV system
I'm using a Zetec 2.0 on Weber 45DCOE's on an Ehrlich igniton (haven't started it up yet), but I'm wondering about the large
metal PCV cannister below the exhaust. It's normally vacuum controlled (with engine vacuum as the "signal" to release the
pressure), but obviously with Webers, there isn't any. I don't want to have internal pressure causing seal leaks or anything.
I'm sure many of you (being an inventive and ingenious lot!) have gotten around this problem. Suggestions? Thanks!
|
|
|
Markp
|
posted on 16/6/06 at 05:17 PM |
|
|
Is this what you mean??
clicky
ATB
Mark
|
|
big_wasa
|
posted on 16/6/06 at 05:40 PM |
|
|
Yep there is pic of mine there with that bit bined. As you say it does bugger all with out the vacume to open it.
|
|
zetec7
|
posted on 16/6/06 at 05:46 PM |
|
|
Pretty much...just want to make sure no-one's had problems with pressure buildup
|
|
Markp
|
posted on 16/6/06 at 05:54 PM |
|
|
no problems at all!!
ATB
Mark
|
|
lsdweb
|
posted on 17/6/06 at 09:23 AM |
|
|
Blank it off - that's the advice from Dunnell's and that's what I did.
|
|