desyboy
|
posted on 28/1/07 at 09:04 AM |
|
|
What engine revs for sva emissions?
Ive just had a my car gas analysed at an mot station and they were: CO .0003, PPM 5 and the lambda just made below 1.03 at 3500 to 4500 rpm. What
engine revs are used for sva emissions . Do you think this would pass sva?
Cheers Des
|
|
|
novacaine
|
posted on 28/1/07 at 10:07 AM |
|
|
dont hold me to this but i though it was 3/4 of your max revs, such as if your engine does 8000rpm they test at 6000 but i might be wrong/confusing
this with motorsport...
cant say for sure...
matt
And you run and you run to catch up with the sun but its sinking, Racing around to come up behind you again, the sun is the same in a relative way but
your older, shorter of breath and one day closer to death
|
|
rusty nuts
|
posted on 28/1/07 at 10:11 AM |
|
|
The 3/4 max revs is for the noise test . Mot test levels are around 3,000 rpm
|
|
smart51
|
posted on 28/1/07 at 10:14 AM |
|
|
for emmissions its 2500 RPM
for noise its 2/3 max power
|
|
davrus
|
posted on 28/1/07 at 10:20 AM |
|
|
as mentioned , the rpm for emissions is any where from 2500 rpm to 3000 , the max for lambda is 1.03 so a little close there but once the revs are
between those limits then the reading should come down , ave reading is 1.00 on lambda.
Cheers
Check out my website http://www.thedave.co.uk/
Feel free to sign my guest book in the links page.
|
|
esn163
|
posted on 28/1/07 at 11:13 AM |
|
|
Just to confirm
BET / CAT Test
Fast idle (2500-3000rpm)
CO<=0.3%
HC<=200ppm
Lambda 0.97-1.03
Idle Test (450-1500rpm)
CO<=0.5%
(From Mar '04 SVA manual)
Noise is at 3/4 max power as already said
HTH
Ed
[Edited on 28/1/07 by esn163]
Indy Build Photos
** Build pages **
Photo Bucket Pics
|
|
02GF74
|
posted on 29/1/07 at 10:03 AM |
|
|
IGNORE what I wrote; though you were asking about noise .... and I got that wrong too
[Edited on 30/1/07 by 02GF74]
|
|
desyboy
|
posted on 29/1/07 at 05:45 PM |
|
|
cheers everyone so which is it 2/3 of max power or 2500 to 3000 rpm?
|
|