Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Pedal Gap Requirement for SVA?
bilbo

posted on 6/4/07 at 09:23 PM Reply With Quote
Pedal Gap Requirement for SVA?

Is there a minimum and maximum gap allowable between the pedals for SVA?

I'm currently making up my pedals. I'm not short of space, but I don't want to fall foul of any regulations.

I've had a search on here and also looked through the SVA manual, but can't see anything?





---------------------------------------

Build Diary: http://bills-locost.blogspot.com/
Web Site: http://locost.atspace.com

View User's Profile Visit User's Homepage View All Posts By User U2U Member
RichardK

posted on 6/4/07 at 09:34 PM Reply With Quote
Can't see anything about it in the sva manual but seem to remember something about a required gap between pedals if you want to race it.

Regards

Rich





Gallery updated 11/01/2011

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
02GF74

posted on 7/4/07 at 06:43 AM Reply With Quote
I'm sure I've seen a distance mentioned; you are right, SVA manaul does not mention anything.

the important thing is that you can operate each pedal safely; I've goot bing plates and little space in the footwell and had to fit brake pedal rubber upside down to avoid pressing brake/accelerator together

Sit in car and mess about withthe pedals wearing your ballet shoes and adjust.

Only other thing about pedals is sharp edges/bolts holes - seem to recall you cannot have those ripspeed/halford ali type cvoers drilled with holes - again can;t recall havingread about that in the SVA so maybe you can.

View User's Profile View All Posts By User U2U Member
caber

posted on 7/4/07 at 07:05 AM Reply With Quote
Not an SVA requirement but 50mm min between edges is standard.

Caber

View User's Profile E-Mail User View All Posts By User U2U Member
chriscook

posted on 7/4/07 at 07:51 AM Reply With Quote
I think the 50mm gap is required for type approval but it is not an SVA requirement.
View User's Profile View All Posts By User U2U Member
bilbo

posted on 7/4/07 at 08:41 AM Reply With Quote
Thanks for all your replies. I'm basically in the process of doing what 02GF74 is suggesting re setting it up to be right for me. Funny enough, the gap is coming out to be about 2", which is just over this 50mm. Just wanted to make sure before the welder comes out





---------------------------------------

Build Diary: http://bills-locost.blogspot.com/
Web Site: http://locost.atspace.com

View User's Profile Visit User's Homepage View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.