Hi guys
i have looked everywhere without any luck
were can i get m18 1.5 fine rose joints to fit my rally design quick camber adjusers.
also where is the cheepest place to purchase replacement sierra front hub bearings the local motorfactor wanted £18 a side is this a reasonable price?
ebay linky for mcgill motorsport.
ive used there stuff on steering and gear linkages and seems good quality. not sure about using a £12 rose joint on suspension...
edit: Blake!! you keyboard demon
[Edited on 30/5/09 by dinosaurjuice]
quote:
Originally posted by dinosaurjuice
ebay linky for mcgill motorsport.
ive used there stuff on steering and gear linkages and seems good quality. not sure about using a £12 rose joint on suspension...
edit: Blake!! you keyboard demon
[Edited on 30/5/09 by dinosaurjuice]
"not sure about using a £12 rose joint on suspension..."
indeed, but what are others experiences of these joints for suspension use? i was looking at buying m16 joints for about 180 quid, if these would be a
reasonable low milage alternative, ie 3 sets would last as long as one set of the higher cost ones or better, so it would be more cost effective to
buy the cheap ones?
edit to add quote, blake was too quick for me to reply right underneath!!
[Edited on 30/5/09 by hellbent345]
i wasnt knocking the quality, i just have no experience of using rose joints on supension so im not really in a position to give out advice
quote:
Originally posted by hellbent345
edit to add quote, blake was too quick for me to reply right underneath!!
ok have ordered those ones. they are for the rear upper wishbone camber adjuster.
i am only getting them as i cant find m18 1.5 studding to make normal bushed camber adjusters
quote:
Originally posted by dinosaurjuice
i wasnt knocking the quality, i just have no experience of using rose joints on supension so im not really in a position to give out advice
i hope they're alright, my whole suspension is made of them. the thinking behind it is they were cheap to get the car built up. if they wear too quick or whatever i'll replace them with expensive ones when they need it. if they turn out good, i'll get some more
good enough for me, ill get them then! i dont need much persuasion to save 130 quids!!
Thankin you
Al
[Edited on 30/5/09 by hellbent345]
i've not driven my car with them yet btw!
but i've spoke to billy himself, he supplies to all the stock car racers at cowdenbeath, i tend to think the stress put through them is likely to
be more on race car suspension. but have a look at the load data on his page, and compare to others.
quote:
Originally posted by ashg
ok have ordered those ones. they are for the rear upper wishbone camber adjuster.
i am only getting them as i cant find m18 1.5 studding to make normal bushed camber adjusters
thats my plan im going to use the rose joints and if they dont last i will cut the thread ends off and weld them to the bush tubes.