Anyone know if the inner and outer lobro on Sierra shafts are the same?

eg: can I use the two lobros from one shaft to modify my push ins??

As far as I am aware the lobro joint at each end of the shaft is the same, we had to replace all 4 on Tim Grays RGB car and the part numbers were all the same
regards
Andy

Hmm, thanks.. how much are new ones BTW?

I seem to remember that we got some pattern ones for about £35 a pair but they didnt last long - that may have been down to the pasting they get in a racecar.
Top end lightened gkn items are silly money so probably best to plumb for a middle of the road items from a local factor
regards
Andy

All four are the same.

I paid £35 for one from a local motor factor.

Not sure about longevity as the diff and driveshafts are still not fitted yet