Has anybody had a driveshaft made up by these guys?
http://www.trackandrally.co.uk/
Need a pair for the single seater, don't really want them breaking.
I had a pair made, by track and rally, for my last bike engined single seater (in 2001)...
You could also try Geoff Berrisford (GB Engineering) he has made me a few special shafts.
[Edited on 20/10/09 by minitici]
The only thing with GB is that I had to keep ringing them to chase them up. They got the lengths and splines right but forgot to gun drill them.
Id waited about 8 weeks by then and they were the last parts of the Motaleira.
Geof (Berresford) did reduce the cost to below that of a non-drilled set, as he would have had to start making them again because of the hardening
process.
Cost me about £280 for the pair.
Most shaft suppliers seem to have similar turn round times.
As martin says budget 6 to 8 weeks!
Thanks guys, much appreciated, I'll be on the phone in the morning to both.
I used bailey morris to make mine and they turned them round in a few days.
Nothing fancy just lightweight shorter than std push-ins.
- Jim
quote:
Originally posted by jimgiblett
I used bailey morris to make mine and they turned them round in a few days.
Nothing fancy just lightweight shorter than std push-ins.
- Jim