After abit of searching about hibs to use for IRS I found this thread http://www.teamswift.net/viewtopic.ph p?f=6&t=45505&sid=4d024d6da8a8bb9f5bfba53df250420e&start=0 and this picture


There saab 900 front hubs and look perfect for use in IRS anyone have any info have done a few searches but cant find anything else using them other people talking about using them on here and on locostusa, oh and late models had 4x108mm bolt pattern...

Why not MX5 (rear)? Is 108 PCD important for you?

What diff you using?

Nah 108 aint important to me as front going be 4x100, thinking that might interested people using sierra parts

Hadent seen MX5 hubs cheap, until an ebay search 5 mins ago

But have seen the saab hubs for as little as £10

Planning using a audi quattro diff I have, got a diff lock so can drift about using it yet flick a switch diff is open and car would have manners

The (4 stud) MX5's are 4x100 I believe (not an expert on this but am likewise researching), plus if you got a whole rear end no issue of mating different make driveshafts to diff etc, plus less complicated then making up an arm to prevent a front hub steering...

HTH