I have a girling master cylinder with a plastic tank on the top for my clutch but the tank fouls the bell housing. I was thinking of having a remote tank connected by a pipe. The fitting on the master cylinder is 7/16 UNF female and male on the tank. So I need a pipe of say roughly 18inches with a male 7/16 UNF on one end and a female on the other. It also needs to be suitable for clutch fluid and pass IVA inspectors intense gaze. I think I might be able to make one up from the stuff that Car Builder Solutions sell but the 7/16 fittings are £6 each!!!

Any thoughts?

Kev

i've got a remote hose set from rally design in the garage going spare. unused
one of these
http://www.rallydesign.co.uk/product_info.php?cPath=562_1357&products_id=10561&osCsid=mftvomh9201p93oqfmlg0vck14

15 squid posted? even got all the banjo bolts and i think, copper washers

did have the remote resevoir too, but ended up using that as a temp fuel tank, so i woudn't use it for fluid