First off I'm looking for a locost supplier of brake fittings. I have male nuts, but things like tees seem to be about £6 each on ebay! Anyone got any good suppliers?

Secondly I need some fittings to cross a bulkhead, ideally to clamp into thin steel and offer a connection on each side. Has anyone seen anything like this which is acceptable for use on brakes?

Cheers

What brake flexies are you using as they using come with bulkhead fittings fitted. Well the ones i've made up do anyway.
these...

Male bulkhead convex seat hose fitting - (3/8 x 24 UNF) or
Male bulkhead convex seat hose fitting - (M10 x 1)



or you can use these....

Hose Fitting M10 x 1 to M10 x 1 male/male bulkhead fitting

[Edited on 17/5/11 by Ben_Copeland]

Or are you talking about copper lines through the bulkhead???

I which case why bother, just run it through a hole

Its a saloon car and I need to come up through the floor to bias valve and handbrake and then back down and would prefer not to need a second person to hold the other side if I ever need to undo the lines.

Bottom ones pictured look good, just make the lines up with female nuts and clamp those in place with a halfnut?

Where did you get them?

Those ones are rally design. £3.50 ish plus vat. But you need the nut aswell

quote:

---

Originally posted by alistairolsen
First off I'm looking for a locost supplier of brake fittings. I have male nuts, but things like tees seem to be about £6 each on ebay! Anyone got any good suppliers?

Secondly I need some fittings to cross a bulkhead, ideally to clamp into thin steel and offer a connection on each side. Has anyone seen anything like this which is acceptable for use on brakes?

Cheers

---