Board logo

Where can I get hubcentric wheel adaptors made
tony.g - 17/11/11 at 10:01 PM

I have a Dolomite rear axle to go on my car which has a PCD of 4x3.75" 95.25mm.
All my wheels are Ford 4x108mm.
Does anyone know where i could have 2 hubcentric adaptors made at a resonable price?
Or does somewhere keep them.
Thanks
Tony

MakeEverything - 17/11/11 at 10:30 PM

If you draw them up on CAD you should be able to get them made up anywhere.

Antnicuk - 17/11/11 at 10:43 PM

DM Motorsport can make them, tell them antnicuk sent you

tony.g - 19/11/11 at 10:51 PM

Thanks for the replies.
I wouldn't know where to start with CAD drawings.
I have emailed DM Motorsport but no reply yet.
I have found someone on ebay that can make them but i'm not sure about using them.

Thanks
Tony

daviep - 19/11/11 at 11:12 PM

If you don't need spacers for width and only to change the PCD would it be possible to re-drill the hub flange and drum to the correct PCD halfway in between the exisiting holes?

Davie

Alan B - 23/11/11 at 07:24 PM

quote:
Originally posted by MakeEverything
If you draw them up on CAD you should be able to get them made up anywhere.


Why CAD?.....surely a decent well dimensioned pencil sketch would suffice?

I use CAD every day so I'm not anti-CAD, just asking a geuine question.

Alan