Hi guys am after a double clip that can be used for both my fuel lines. I have seen some but they all need about 8mm holes in the chassis rail to mount them . are there any clips that would be a bit neater, I currently have the 3.2mm holes for the rivets. I want to use this but dont mind opening them up a bit further. but not 8mm each.

Thanks

Can you not just rivet 2 Pclips per hole, 180 degrees opposed?

I could but with the current layout the bottom pipe would be touching the handbrake bracket in the tunnel. due to the length of the neck on the p-clip. if you understand what i mean. Just thought there might be an easier/neater solution out there

HEL sell these. Have a look here:
http://helperformance.com/store/product_info.php?cPath=10&products_id=3534

That's a rubbish pic of the HEL unit, I have some of the HEL ones in stock in blue anodised ali £4ea plus P & P, they look a lot better than that pic does, if I have a pic will post it in a bit.

There you go


[img]
[/img]


[img]
[/img]

I think that's a slight improvement on the HEL pic!!!

I would asume as they are quite wide they would give the same problem as using 2 clips though.
maybe these?
http://www.lrseries.com/shop/product/listing/5699/3839/1/ESR1373-PIPE-CLIP-DOUBLE-8MM.html

Thanks guys,

Russ that is shiny but the price reflects it.