LocostBuilders - powered by XMB

Question for MG Rover Gurus---Britishtrident??

liam.mccaffrey - 13/9/13 at 07:25 PM

Does anyone know whether the male splines on the outer end of an mgzr 160 driveshaft fit the internal splines of a mgtf outer CV joint?!?!?!?!

I've heard they do?!

Daddylonglegs - 13/9/13 at 08:15 PM

Sounds like something from Monty Python's

Rob180bhp - 13/9/13 at 08:30 PM

Id say yes

britishtrident - 14/9/13 at 09:40 AM

Don't know all I know is the splines at the other end should be the same as they both use the PG1 gearbox, so it looks like you need to give it the ice lolly test --- suck it and see.

liam.mccaffrey - 14/9/13 at 01:21 PM

I think at least the spline count is the same, I'm going to get a MGTF CV joint and try it.
I'll let you know BT

Rob180bhp - 14/9/13 at 02:02 PM

I used to work for mg/rover/austin

And alot of parts mix and match

Very few cars had 1 off generic parts

Cars were designed from the stock they had to hand to keep costs down
I had a tour of alot of the factories and test facilities

liam.mccaffrey - 14/9/13 at 05:08 PM

thats good info rob, cheers bud