One of my CV boots is leaking on my push-in shafts - at the bit where your hammer the edge round the seal. My bro sorted it for me last in 2009. He's just rung Ford with the same part numbers (found the old order) and Ford no longer sell it, apparently stopped last year because it's "so old".

Does anyone know of any other sources of these - it's the boot including can that's required, so the aftermarket glued boots are no good (it's the can that's fooked - or at least it will be when we remove it to get to the seal that's moved/perished/whatever).

Cheers,


Simon

on ebay for a tenner, boot, grease tin can and shaft clamp

You can get New shafts on eBay for around £70
This : FORD SIERRA 2.0 PETROL DRIVESHAFT NEAR/SIDE &' CV JOINT 1982 1993

[Edited on 3-7-14 by 40inches]