Hi all,

I have decided on using the Uno bias valve, as adjustability is good (as long as not for SVA) for the future (rear disks, tract days etc).

My question is, where should I fit it? I was thinking under the master cylinder, as there is very little room at the rear (plus its easy to get to in the future to play with). Any problems doing this?

have a look at bob,s photo archive,thats where he put his

I looked at that photo and couldn't figure out where it was!

Who made the bracket?

From front of car looing into engine bay,the bias valve is to the left of master cylinder tucked away nicely in corner.

going by the crappy welding the bracket could be one of mine