I'm sure i read on here somewhere about how many turns of thread should be sticking out from a the nylon of the nuts. I used a washer bothsides of the wisbone pivots and this only allowed one turn of a thread to be showing. Is this a probllem for SVA?

If it's sticking out the other side, I would have said it's fine, if you're particularly worried though, drill a hole through it, and put some lock wire through it.

Kingr

As a general rule of thumb, the length of thread protruding through a nut should equal its diameter.

ISTR that Mr SVA wants a minimum of two threads.

whats "ISTR"??

[Edited on 4/3/03 by MK9R]

I seem to remember? - Just a guess

Kingr

arrh i see, internet geek talk!!

MK9R:

quote:

---

whats "ISTR"??

---

Where are people sourcing the bolt head / nut / exposed thread covers from?

Namrick in Portslade do them.

Try TIFOSI
http://www.tifosi-devon.co.uk/