What size are the BIG nuts that hold the front hub on? I've measured it at 40mm but the socket sets have a 41mm socket. Wil that be OK?
Also what size the nut on the rear drive shaft?

Cheers

Steve

Hi mate
I used 41mm all round, No probs hope this helps

Hi Steve,

On my Sierra XR4x4 donor the rears were 41mm socket. I measured it at 40mm, went and bought a 40mm socket and it was too small!

41mm did the job fine though.

Mart.

Cheers lads, off to ebay for a f@%k off big socket set!!

Dunno if it helps but I got mine from my local fastenings place.

Hard to find in 1/2" drive though. I had to get a 3/4" drive socket and a reducer to use it with a 1/2" drive bar.

Mart.

The parts shop sells them in 1/2" drive for the Sierra bearing nuts, I bought one a couple of weeks ago. Laser or Silverline tools do them. One here better than buying a 3/4" drive set you'll only use one socket out of.

quote:

---

Originally posted by Cheffy
Hi Steve,

On my Sierra XR4x4 donor the rears were 41mm socket. I measured it at 40mm, went and bought a 40mm socket and it was too small!

41mm did the job fine though.

Mart.

---

Just got a nice3/4 drive socket set off ebay. The rest of the sockets will come in handy somewhere. lol