I got this master cylinder with a load of bits when I picked up my part built indy


I'm going to be running disks front and drums rear for now.
Normal sierra has two outputs to the calipers and one to the rear split with a t-piece.

I was considering useing this instead as it's all alloy and weighs a fraction of the cast sierra jobby.
But it's got two front outputs and two to the rear (although smaller diameter!).

Will this be suitable for rear drums do you think? could I blank off one of the rear outputs or just run two pipes?

Cheers
Pez

[Edited on 16-5-06 by Pezza]

You could blank off one the outlets to the rear with a brake light pressure sensor

Kill two birds with one stone

good thinking!
cheers

Mondeo I think --

[Edited on 17/5/06 by britishtrident]

Defo looks like a 93~00 Mondeo one. 2x12mm outlets and 2x10mm

£44.93+Vat on Brakes International