Does anyone have a scan of the haynes for the XR4x4 rear axle or some similar manual?

I only want to know a couple of things but its always good to read a manual before doing a job.
Really i'm mainly looking for the torque setting for the hub nut and how the driveshaft CV joints are assembled.

Also, what type of grease should i use in the rear wheel bearings during rebuild?

Thanks!

Just strip them down, really easy. Don't listen to people saying how difficult they are to re-assemble, because they're easy.

If you get them wrong then you won't get the degrees of motion. Just re-do it.

Make sure everything is clean and by the way the boots come with the grease.