Hi,

I tried to mount the axle on the Sierra differential with standard M10 bolts.
When i was mounting them it feld tike the bolts were going in really hard.
I didn't trust it so inspectected one bolt when i took it out again and whaaa
the new bolt was looking really bad.
What kind of bolt do i have to use between a Sierra diif and axle ?
Sorry for my bad English.

Thanks, Marco

[Edited on 22/7/06 by marcotuinenburg]

IIRC, they are M10, but 1mm thread pitch (M10 FINE), not 1.5mm thread pitch like normal bolts.

Pat...

aha, know i have to find out where i can find a set of bolts.
Probably that will by the good old junkyard

Thanks for the advice

If you can't get any, they're easy to get here and postage isn't much.

Pat...

Got mine from a local fixings place, two quid for a dozen was all they charged

quote:

---

Originally posted by marcotuinenburg

When i was mounting them it feld tike the bolts were going in really hard.
I didn't trust it so inspectected one bolt when i took it out again and whaaa
the new bolt was looking really bad.
[Edited on 22/7/06 by marcotuinenburg]

---

They're M10x1x18mm.
Ford part number:- P F6118344 182582 screw @ 76p each plus VAT.
As long as they're 8.8 grade they'll be OK from any stockist though.

Cheers
Steve

Remember this guy lives in Holland though!

Pat...

Ah.....good point. Sorry Marco!
If it's any consolation, they were like rocking horse poo around here when I was after some anyway :-)))
Looks like Pat's offer is the best bet