hi all can anybody tell me what car this could have poss been on as they didnt know in trw braking and will it be ok for my build
Rescued attachment new master cylinder.jpg

What's the coding on the red band?

ford. poss fiesta mk3 ish for a quess but may be wrong

I might be able to help but I can't be bothered to wait for your huge picture to download.

Looks like a westy one

Yes its a westy one, they also use the same one in the caterham. They don't use them as standard on anything else.(that isn't a kit car)
I've just bought one from westfield for my Striker.

thanks steve so it will be ok for mey build
cheers
colin

Girling --- non-servo type.
Looks like it is off either a MK3 Cortina 1300 (without servo) or a MK1 Fiesta (without servo) or a Trumph GT6 or a late 70s early 80s FX4D Taxi.

Which depends on bore of cylinder istr the Fords were 0.75" bore and the Triumph and FX4D cylinder was a 0.7" bore. The Triumph/FX4d cylinder was used by Westy --- a few of these come on to the market because Wesfield include a bigger bore cylinder in thier uprated brake kit.

0.7" bore is a bit on the small side for a single cylinder system ---- it will give light pedal pressure but the volume it pumps is just OK with standard Cortian/Sierra calipers don't use it with bigger calipers.

The only reason bore and volume pumped is important is to deal with a stuation when something goes wrong with the system and you have to pump the pedal.