just had a sudden panic attack, i just stuck the magnets to the prob, is there a way they should go eg north or south pole to the sensor? i hope not as i cant rememebr how i mounted them and there now in the tunnel now

If they are the small round ones (about 6mm diameter) from etb they have a small dimple in one end that should point outwards

oh dear, whats the chances of me putting them that way around

That's my guess anyway

If they all point the same way it's worth a try before chipping them all off again.

quote:

---

Originally posted by Peteff
50/50

That's my guess anyway

---

quote:

---

Originally posted by graememk
just had a sudden panic attack, i just stuck the magnets to the prob, is there a way they should go eg north or south pole to the sensor? i hope not as i cant rememebr how i mounted them and there now in the tunnel now

---

When I was experimenting I found they all had to face the same way or I missed pulses.

I was using retangular ones, both the same way up and orinentaion.

Its easy to check, just get another magnet and see how it behaves against the prop as you turn.

Regards Mark

If you do remove them i would drill a shallow 6mm hole to sit them in next time. This was recommended to me by ETB when i was experiencing problems keeping them in place after use.
Obviously you still need to use good glue as well.

[Edited on 9/2/07 by DarrenW]