Will my abs hub with the splined bit for the sensor fit ok in a non abs upright. I need to get a new upright and i cant get an ABS one for ages so i was wondering if the hub and upright would go together ok.

Thanks

are you talking sierra front into sierra upright or sierra rear into MK upright?

Ned.

If you are talking about the rear one I had the same problem. MKs answer was to have the grooved section removed either with a file or turned off on a lathe and then they fit. Normal ones dont have the same problem. Give MK a ring to check if still the case.

Greggors, don't suppose a 4x4 ABS upright would be any use to you would it? we'll have a couple of those with no home to go to soon.

No i mean front

I assmed you meant fronts. we only want the back bits or our sierra, front uprights are surplus to requirements.

that's why I dunno if 4x4 are any good to you, maybe you could retrofit the stub axle into them or something?

shout if you want em anyway

[Edited on 11/9/03 by blueshift]