made a template for my pedals, have now cut a bit of 3mm plate to weld in, soon be able to bolt the brake and clutch pedals in.

I'll be attempting to make my own accelerator pedal.
Rescued attachment 7_05_08 016.jpg

no matter how hard I look I cannot see any plate or template

sorry it's not obvious!
I jacked up the plywood under the chassis and screwed the pedals into position. After several attempts i was happy with the positions.
I then drew round the whole thing in pencil and traced it off the plywood.

Please see attached word document showing my proposed accelerator pedal.
Not sure what ratio you should have for 'A' or 'B' marked on drawing.

Please note that i will be strengthening the duct tape connections to the steering column.

I've only just extended the steering column with a sleeve, most things are currently held in place with ties/duct tape!

quote:

---

Originally posted by rumplitter
sorry it's not obvious!
I jacked up the plywood under the chassis and screwed the pedals into position. After several attempts i was happy with the positions.
I then drew round the whole thing in pencil and traced it off the plywood.

---

quote:

---

Originally posted by Mr Whippy

quote:

---

Originally posted by rumplitter
sorry it's not obvious!
I jacked up the plywood under the chassis and screwed the pedals into position. After several attempts i was happy with the positions.
I then drew round the whole thing in pencil and traced it off the plywood.

---

ha I see, thank god cos I had a nagging doubt that wood for the floor

---