Sierra 3.62 LSD 7" diff, bolt on type drive shafts
Got a few of these, all in good working order, just give them a clean and a paint and they can go straight in the car.
£200
[Edited on 9/3/16 by MK9R]
quote:
Originally posted by MK9R
Got a few of these, all in good working order, just give them a clean and a paint and they can go straight in the car.
£200
Courier not a problem, will be £15
U2u sent
diffs are bolt on type drive shafts, first post now updated with info
I got mine and its on it way
many thanks
Very interested in one... i will measure my diff tomorrow and see if it is a 7".
quote:
Originally posted by ash_hammond
Very interested in one... i will measure my diff tomorrow and see if it is a 7".
quote:
Originally posted by MK9R
quote:
Originally posted by ash_hammond
Very interested in one... i will measure my diff tomorrow and see if it is a 7".
I do have a couple of 7.5 " too but will need to know quickly on them as I have a buyer for these (obviously LCB get priority)
quote:
Originally posted by ash_hammond
quote:
Originally posted by MK9R
quote:
Originally posted by ash_hammond
Very interested in one... i will measure my diff tomorrow and see if it is a 7".
I do have a couple of 7.5 " too but will need to know quickly on them as I have a buyer for these (obviously LCB get priority)
I get home tomorrow evening, is that too late?
I know mine is a 3.62 with push in shafts if that helps us narrow it down?
PM sent.
Hi.
Just been told the MAC#1 chassis by default takes a 7" diff.
I never specificity a diff size so I'm 90% certain mines a 7". My dad is going to measure it for me later on so i can be very certain.
So can I please have my name on a 7"? I'm going to assume if it does turn out to me a 7.5 there are non left, but i should be certain later
on this evening.
Cheers.
Ash
Was just about to phone you!! Make sure he measures acroos the top mounts not the bottom.
I've put you down for 1. Let me know when it's checked and I will send you bank details etc
Drop us a line if its easier. Always good to talk.
Yep... this is how i was going to measure.
Bang on. You can tell by the casting on the back plate too, but we won't go into that
You need 100mm bolt on flanges for these
I've still got a few left
still a few left.
i do have a 3.38 crown wheel and pinion aswell, but can only supply this as a fully recon unit as will have to be built up into a casing. could be
supplied as LSD or open
U2U sent
Best regards
Ross Carter
bump up
U2U sent.
Dougie
Back at ya
still got a few left
do you have any drive shafts to go with a diff?
sorry no
some info on mixing and matching driveshafts
If the drive shafts are 25 spline versions ie non cossie the tripod (non lsd) CV joint can be take off the shaft and replaced with a lobro CV joint
(lsd).
I have the push in shafts now on a open diff in my reliant Sabre I need a set of lobro shafts to convert it
Bump it up
I sent you a U2U.
Any left?
I can't seem to access my U2Us, but I am in need of that diff we spoke about previously.